Saving Configuration Changes - Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual

Chapter 4 Configuring the Data Interfaces

Saving Configuration Changes

Task
Step 1 Enter enable mode.
Enter the password.
You know you have entered enable
mode when the prompt changes to
.
gateway#
Step 2
Save the configuration changes to
NVRAM so that they are not lost
during resets, power cycles, or
power outages.
Step 3
Return to enable mode.
This message is normal and does
not indicate an error.
OL-2031-02
To prevent the loss of the Catalyst 4224 configuration, you need to save it to
NVRAM.
To save configuration changes, perform these steps:
Command
gateway> enable
Password: password
gateway#
gateway# copy running-config startup-config
[or]
gateway# write memory
gateway(config-if)# Ctrl-z
gateway#
%SYS-5-CONFIG_I: Configured from console by
console
Catalyst 4224 Access Gateway Switch Software Configuration Guide
Saving Configuration Changes
4-19