Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual page 164

Configure Dial Peers
Figure 6-5 Outgoing Calls, from the Perspective of POTS Dial Peer 1
Source
Voice port
0/0
(408) 555-4000
POTS call leg
dial peer 1
Figure 6-6 Outgoing Calls, from the Perspective of POTS Dial Peer 2
Destination
Catalyst 4224
Voice port
0/0
(408)
555-4000
Catalyst 4224 Access Gateway Switch Software Configuration Guide
6-18
Catalyst 4224
10.1.2.2
V
To configure call connectivity between the source and the destination as
illustrated in Figure 6-5, enter the following commands on Catalyst 4224
10.1.2.2:
c4224(config)# dial-peer voice 1 pots
c4224(config-dial-peer)# destination-pattern 14085554000
c4224(config-dial-peer)# port 0/0
c4224(config)# dial-peer voice 2 voip
c4224(config-dial-peer)# destination-pattern 13105551000
c4224(config-dial-peer)# session target ipv4:10.1.1.2
Figure 6-6 shows how to complete the end-to-end call between dial peer 1 and dial
peer 4.
10.1.2.2
V
VoIP call leg
dial peer 3
10.1.1.2
IP cloud
VoIP call leg
dial peer 2
Catalyst 4224
10.1.1.2
IP cloud
Chapter 6 Configuring VoIP
Destination
Catalyst 4224
Voice port
0/0
V
(310) 555-1000
Source
Voice port
0/0
V
(310)
POTS call leg
555-1000
dial peer 4
OL-2031-02