Table of Contents
Advertisement
Chapter 4
Configuring the Cisco PGW 2200 Softswitch Software
Enter snmpCommunityName:
Step 3
Enter an SnmpCommunityName. Select an SnmpCommunityName from the list that is displayed in
Step
T555
Text similar to the following is displayed:
snmpCommunityName: T555 is about to be deleted.
snmpCommunity Name
Step 4
Enter y to confirm the deletion (if you enter n to cancel the deletion, you return to the SNMPD
Configuration Main Menu).
Text similar to the following is displayed and you are returned to the SNMPD Configuration Main Menu:
Deleting snmpCommunity= T555
===================
1. View Configuration Entries
2. Add an SNMP Community
3. Delete an SNMP Community
4. Add a Trap Destination
5. Delete a Trap Destination
6. Activate the New Settings
Enter a selection (1 through 6) or 'q' to quit:
Step 5
Enter your selection. For detailed procedures for your selection, refer to the following list:
•
•
•
•
•
•
The procedure for deleting an SNMP Community Entry is now complete. Proceed to the selection you
entered in the SNMPD Configuration Main Menu.
Adding a Trap Destination
From the SNMPD Configuration Main Menu:
Step 1
Select option 4 (Add a Trap Destination) from the SNMPD Configuration Main Menu and press Enter
to add a Trap Destination.
The Add Trap Menu is displayed:
Note
OL-18083-14
1. The SnmpCommunityName T555, is an example:
[y]/[n]?
SNMPD Configuration Main Menu
Adding an SNMP Community Entry, page 4-18
Deleting an SNMP COMMUNITY, page 4-20
Adding a Trap Destination, page 4-21
Deleting a Trap Destination, page 4-23
Activating the New Settings, page 4-24
Verifying the SNMP Configuration Migration, page 4-25
The IP Address (Target Address) listed below is an example of existing Trap entries.
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
Configuring SNMP Support Resources
Are you sure that you want to delete this
===================
4-21
Advertisement
Table of Contents
