Vlan Membership Modes - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual
Desktop switch
Hide thumbs
Also See for 2950G 24 - Catalyst Switch:
- Migration manual (25 pages) ,
- Datasheet (19 pages) ,
- Product support bulletin (5 pages)
Table of Contents
Advertisement
Chapter 3
Getting Started with CMS
To select or change a mode, click the Mode button until the desired mode LED is green.
Table 3-4
Port Modes
Mode LED
Description
STAT
Link status of the ports or the Ethernet link status on the remote customer premises equipment
(CPE) device. This is the default mode except for the Catalyst 2950 LRE switches.
DUPLX
Duplex setting on the ports. The default setting on the 10/100 ports is auto. The default setting
on the 10/100/1000 ports is full.
SPEED
Speed setting on the ports. The default setting on the 10/100 and 10/100/1000 ports is auto.
Table 3-5
Port LEDs
Port Mode
Port LED Color
STAT
Cyan (off)
Green
Amber
Brown
DUPLX
Cyan (off)
Green
SPEED
Cyan (off)
Green
Blinking green
VLAN Membership Modes
Ports in the Front Panel view are outlined by colors (see
Port Membership Modes on the Configure VLANs tab on the VLAN window
(VLAN > VLAN > Configure VLANs). The colors show the VLAN membership mode of each port.
The VLAN membership mode determines the kind of traffic the port carries and the number of VLANs
it can belong to. For more information about these modes, see the
section on page
Note
This feature is not supported on the Catalyst 1900 and Catalyst 2820 switches.
78-14982-01
Description
No link.
Link present.
Link fault. Error frames can affect connectivity, and errors such as excessive
collisions, CRC errors, and alignment and jabber errors are monitored for a link-fault
indication.
Port is not forwarding. Port was disabled by management, by an address violation,
or by Spanning Tree Protocol (STP).
Note
After a port is reconfigured, the port LED can remain amber for up to
30 seconds as STP checks the switch for possible loops.
No link and port is administratively shut down.
Port is operating in half-duplex mode.
Port is operating in full-duplex mode.
Port is operating at 10 Mbps (10/100 ports) or no link (10/100/1000 ports and GBIC
module ports).
Port is operating at 100 Mbps (10/100 ports) or 1000 Mbps (GBIC module ports).
Port is operating at 1000 Mbps (10/100/1000 ports).
14-3.
Table
3-6) when you click Highlight VLAN
"VLAN Port Membership Modes"
Catalyst 2950 Desktop Switch Software Configuration Guide
Front Panel View
3-9
Advertisement
Table of Contents
Troubleshooting
