Cisco 2950G 24 - Catalyst Switch Software Configuration Manual page 497

Chapter 25 Configuring Network Security with ACLs
• Layer 4 fields:
–
–
A mask can be a combination of either multiple Layer 3 and Layer 4 fields or of multiple Layer 2 fields.
Note
Layer 2 fields cannot be combined with Layer 3 or Layer 4 fields.
There are two types of masks:
User-defined mask—masks that are defined by the user.
•
System-defined mask—these masks can be configured on any interface:
•
Switch (config-ext-nacl)# permit tcp any any
Switch (config-ext-nacl)# deny tcp any any
Switch (config-ext-nacl)# permit udp any any
Switch (config-ext-nacl)# deny udp any any
Switch (config-ext-nacl)# permit ip any any
Switch (config-ext-nacl)# deny ip any any
Switch (config-ext-nacl)# deny any any
Switch (config-ext-nacl)# permit any any
Note
The switch ACL configuration is consistent with other Cisco Catalyst switches. However, there are
significant restrictions for configuring ACLs on the switches.
Only four user-defined masks can be defined for the entire system. These can be used for either security
or quality of service (QoS) but cannot be shared by QoS and security. You can configure as many ACLs
as you require. However, a system error message appears if ACLs with more than four different masks
are applied to interfaces. For more information about error messages, see the system message guide for
this release.
Table 25-1
Table 25-1 Summary of ACL Restrictions
Restriction
Number of user-defined masks allowed in an ACL 1
Number of ACLs allowed on an interface
Total number of user-defined masks for security
and QoS allowed on a switch
78-14982-01
TCP (You can specify a TCP source, destination port number, or both at the same time.)
UDP (You can specify a UDP source, destination port number, or both at the same time.)
In an IP extended ACL (both named and numbered), a Layer 4 system-defined mask cannot
precede a Layer 3 user-defined mask. For example, a Layer 4 system-defined mask such as
permit tcp any any or deny udp any any cannot precede a Layer 3 user-defined mask such as
permit ip 10.1.1.1 any. If you configure this combination, the ACL is not allowed on a Layer 2
interface. All other combinations of system-defined and user-defined masks are allowed in
security ACLs.
lists a summary of the ACL restrictions on the switches.
Number Permitted
1
4
Catalyst 2950 Desktop Switch Software Configuration Guide
Understanding ACLs
25-5