Clearing Configuration Information; Clearing The Startup Configuration File - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual

Appendix B Working with the IOS File System, Configuration Files, and Software Images
Command
Step 4 ip rcmd remote-username username
Step 5
end
Step 6 copy system:running-config
rcp:[[[//[username@]location]/directory]/filename]
or
copy nvram:startup-config
rcp:[[[//[username@]location]/directory]/filename]
This example shows how to copy the running configuration file named switch2-confg to the netadmin1
directory on the remote host with an IP address of 172.16.101.101:
Switch# copy system:running-config rcp://netadmin1@172.16.101.101/switch2-confg
Write file switch-confg on host 172.16.101.101?[confirm]
Building configuration...[OK]
Connected to 172.16.101.101
Switch#
This example shows how to store a startup configuration file on a server:
Switch# configure terminal
Switch(config)# ip rcmd remote-username netadmin2
Switch(config)# end
Switch# copy nvram:startup-config rcp:
Remote host[]? 172.16.101.101
Name of configuration file to write [switch2-confg]?
Write file switch2-confg on host 172.16.101.101?[confirm]
![OK]

Clearing Configuration Information

You can clear the configuration information from the startup configuration. If you reboot the switch with
no startup configuration, the switch enters the setup program so that you can reconfigure the switch with
all new settings.

Clearing the Startup Configuration File

To clear the contents of your startup configuration, use the erase nvram: or the erase startup-config
privileged EXEC command.
Caution You cannot restore the startup configuration file after it has been deleted.
78-14982-01
Purpose
(Optional) Specify the remote username.
Return to privileged EXEC mode.
Using RCP, copy the configuration file from a switch running
or startup configuration file to a network server.
Catalyst 2950 Desktop Switch Software Configuration Guide
Working with Configuration Files
B-19