Cisco 2950G 24 - Catalyst Switch Software Configuration Manual page 147

Chapter 6 Clustering Switches
If a candidate switch in the group has a password different from the group, only that specific candidate
switch is not added to the cluster.
When a candidate switch joins a cluster, it inherits the command-switch password. For more information
about setting passwords, see the
For additional authentication considerations in switch clusters, see the
section on page
Figure 6-11 Add to Cluster Window
2900-LRE-24-1
78-14982-01
"Passwords" section on page
6-17.
6-16.
Catalyst 2950 Desktop Switch Software Configuration Guide
Creating a Switch Cluster
"TACACS+ and RADIUS"
Select a switch, and click
Add. Press Ctrl and left-
click to select more than
one switch.
Enter the password of
the candidate switch. If
no password exists for
the switch, leave this
field blank.
6-21