Cisco 2950G 24 - Catalyst Switch Software Configuration Manual page 233

Chapter 9 Configuring the Switch Interfaces
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#
Enter the interface global configuration command. Identify the interface type and the number of the
Step 2
connector. In this example, Gigabit Ethernet interface 0/1 is selected:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)#
Note
Follow each interface command with the interface configuration commands your particular interface
Step 3
requires. The commands you enter define the protocols and applications that will run on the interface.
The commands are collected and applied to the interface when you enter another interface command or
enter end to return to privileged EXEC mode.
You can also configure a range of interfaces by using the interface range or interface range macro
global configuration commands. Interfaces configured in a range must be the same type and must be
configured with the same feature options.
Step 4 After you configure an interface, verify its status by using the show privileged EXEC commands listed
in the
Enter the show interfaces privileged EXEC command to see a list of all interfaces on or configured for
the switch. A report is provided for each interface that the device supports or for the specified interface:
Switch# show interfaces
Vlan1 is up, line protocol is up
Hardware is EtherSVI, address is 0000.0000.0000 (bia 0000.0000.00
Internet address is 10.1.1.64/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
Encapsulation ARPA, loopback not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:35, output 2d14h, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 1 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
FastEthernet0/1 is up, line protocol is down
Hardware is Fast Ethernet, address is 0000.0000.0001 (bia 0000.00
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto-speed
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
78-14982-01
You do not need to add a space between the interface type and interface number. For example,
in the preceding line, you can specify either gigabitethernet 0/1, gigabitethernet0/1, gi 0/1, or
gi0/1.
"Monitoring and Maintaining the Interfaces" section on page
reliability 255/255, txload 1/255, rxload 1/255
264251 packets input, 163850228 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
380 packets output, 26796 bytes, 0 underruns
0 output errors, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
reliability 255/255, txload 1/255, rxload 1/255
9-16.
Catalyst 2950 Desktop Switch Software Configuration Guide
Using the Interface Command
9-5