Understanding The Port Aggregation Protocol - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual

Chapter 27 Configuring EtherChannels
Figure 27-2 Relationship of Physical Ports, Logical Port Channels, and Channel Groups
SYS T
RPS
STA T
UTIL
DUP LX
SPE ED
MOD E
After you configure an EtherChannel, configuration changes applied to the port-channel interface apply
to all the physical interfaces assigned to the port-channel interface. Configuration changes applied to the
physical interface affect only the interface where you apply the configuration. To change the parameters
of all ports in an EtherChannel, apply configuration commands to the port-channel interface, for
example, spanning-tree commands or commands to configure a Layer 2 EtherChannel as a trunk.

Understanding the Port Aggregation Protocol

The Port Aggregation Protocol (PAgP) facilitates the automatic creation of EtherChannels by
exchanging packets between Ethernet interfaces. By using PAgP, the switch learns the identity of
partners capable of supporting PAgP and learns the capabilities of each interface. It then dynamically
groups similarly configured interfaces into a single logical link (channel or aggregate port); these
interfaces are grouped based on hardware, administrative, and port parameter constraints. For example,
PAgP groups the interfaces with the same speed, duplex mode, native VLAN, VLAN range, and trunking
status and type. After grouping the links into an EtherChannel, PAgP adds the group to the spanning tree
as a single switch port.
78-14982-01
Logical
port-channel
Channel-group
binding
1
2
3
4
5
6
1X 7
8
9
10
11
12
13
11X 14
15
16
17
18
13X 19
20
21
22
2X 23
24
23X
12X
14X
24X
10/100 ports
Physical
ports
Logical
port-channel
Ca tal ys t 29
50
1
SER IES
2
GBIC module
slots
Catalyst 2950 Desktop Switch Software Configuration Guide
Understanding EtherChannels
27-3