Hardware - Onkyo HT-S5400 Instruction Manual

Setting the Incoming Digital Signal (Fixed
Mode)
■
Fixed Mode
Off:
The format is detected automatically. If no digital
input signal is present, the corresponding analog
input is used instead.
PCM:
Only 2-channel PCM format input signals will be
heard. If the input signal is not PCM, the PCM
indicator will flash and noise may also be produced.
DTS:
Only DTS (but not DTS-HD) format input signals
will be heard. If the input signal is not DTS, the DTS
indicator will flash and there will be no sound.
When "HDMI", "COAXIAL" or "OPTICAL" is
selected in the "Audio Selector" setting, you can then
specify the signal type in "Fixed Mode".
Normally, the AV receiver detects the signal format
automatically. However, if you experience either of the
following issues when playing PCM or DTS material, you
can manually set the signal format to PCM or DTS.
• If the beginnings of tracks from a PCM source are cut
off, try setting the format to PCM.
• If noise is produced when fast forwarding or reversing a
DTS CD, try setting the format to DTS.
Note
• The setting will be reset to "Off" when you change the setting in
page 40).
the "Audio Selector" (➔
.

Hardware

Menu Hardware
OSD Setting
■
Volume OSD
On
Off
You can select if you wish to display the volume level on-
screen, when it is adjusted.
Remote Control Settings
■
Remote ID
1, 2, or 3
When several Onkyo components are used in the same
room, their remote ID codes may overlap. To differentiate
the AV receiver from the other components, you can
change its remote ID from "1", to "2" or "3".
Note
• If you do change the AV receiver's remote ID, be sure to change
the remote controller to the same ID (see below), otherwise, you
won't be able to control it with the remote controller.
Changing the remote controller's ID
1
While holding down RECEIVER, press and hold
down SETUP until the remote indicator lights
(about 3 seconds) (➔
2
Use the number buttons to enter ID 1, 2, or 3.
The remote indicator flashes twice.
Tuner
■
AM/FM Freq Step (North American and Brazilian
models)
10kHz/200kHz:
9kHz/50kHz:
Select the frequency step according to your area.
■
AM Freq Step (Asian models)
10kHz:
9kHz:
Select the frequency step according to your area.
For AM/FM tuning to work properly, you must specify the
AM/FM frequency step used in your area. Note that when
this setting is changed, all radio presets will be deleted.
Auto Standby
■
Auto Standby
Off
On
When "Auto Standby" is set to "On", AV receiver will
automatically perform standby operation if there is no
operation for 30 minutes with no audio and no video
signal input.
"Auto Standby" will display on the display and OSD
from 30 seconds before the Auto Standby functions.
Default setting: On (Asian models), Off (North
American and Brazilian models)
Note
• Depending on some sources, the Auto Standby function may
activate during playback.
page 34).
En
41