Connections; Connecting The Av Receiver; Connecting Your Speakers - Onkyo HT-S5400 Instruction Manual

Connections

Connecting the AV Receiver

Connecting Your Speakers

Connecting the Speaker Cables
The following illustration shows which speaker should be connected to each pair of terminals. If you're using only one
surround back speaker, connect it to the SURROUND BACK or FRONT HIGH L terminals.
Surround back/
front high
right
Tip
• You can specify whether surround back or front high speakers are connected in the "Sp Config (Speaker Configuration)" menu
(➔ page 36) or during Audyssey 2EQ
■
Screw-type speaker terminals
Strip 1/2" to 5/8" (12 to 15 mm) of insulation from
the ends of the speaker cables, and twist the bare
wires tightly, as shown.
■
Banana Plugs (excluding Asian models)
• If you are using banana plugs, tighten the speaker terminal before inserting the banana plug.
• Do not insert the speaker code directly into the center hole of the speaker terminal.
Surround back/
front high Surround
left right
® Room Correction and Speaker Setup
Surround
left Center
Front right
(➔ page 24).
1/2" to 5/8" (12 to 15 mm)
Front left
En
11