Controlling Other Onkyo Components; Preprogrammed Remote Control Codes; Entering Remote Control Codes; Remote Control Codes For Onkyo Components Connected Via - Onkyo HT-S5400 Instruction Manual

Controlling Other Onkyo Components

You can use the AV receiver's remote controller to
control your other Onkyo AV components. This section
explains how to enter the remote control code (with the
default underlined) for a component that you want to
control: DVD, CD, etc.
Preprogrammed Remote Control
Codes
The following REMOTE MODE are preprogrammed
with remote control codes for controlling the components
listed. You do not need to enter a remote control code to
control these components.
For details on controlling these components, see the pages
indicated.
BD/DVD Onkyo Blu-ray Disc player
TV/CD Onkyo CD player (➔

Entering Remote Control Codes

You'll need to enter a code for each component that you
want to control.
1
Look up the appropriate remote control code in the
Remote Control Codes for Onkyo Components
Connected via .
2
While holding down REMOTE MODE to which
you want to enter a code, press and hold down
DISPLAY (about 3 seconds).
Note
• Remote control codes cannot be entered for RECEIVER.
• Apart from RECEIVER, remote control codes from any
category can be entered for REMOTE MODE. However,
these buttons also work as input selector buttons
(➔ page 19), so choose a REMOTE MODE that
corresponds with the input to which you connect your
component. For example, if you connect your CD player to
the CD input, choose TV/CD when entering its remote
control code.
3
Within 30 seconds, use the number buttons to enter
the 5-digit remote control code.
The remote indicator flashes twice.
If the remote control code is not entered successfully,
the remote indicator will flash once slowly.
page 48)
(➔
page 48)
Remote Control Codes for Onkyo
Components Connected via
Onkyo components that are connected via
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
1 Make sure the Onkyo component is connected with
an cable and an analog audio cable (RCA).
See "Connecting Onkyo
(➔ page 16).
2
Enter the appropriate remote control code for
REMOTE MODE referring to the previous section.
42157:
Onkyo cassette tape deck with
81993:
Onkyo Dock with
3
Press REMOTE MODE, point the remote
controller at the AV receiver, and operate the
component.
Controlling Onkyo components without
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that's not connected via
following remote control codes:
30627:
Onkyo DVD player without
71817:
Onkyo CD player without
32900/33000:
Onkyo Blu-ray Disc player
32901/33004
Onkyo HD DVD player
70868:
Onkyo MD recorder without
71323:
Onkyo CD recorder without
82990:
Onkyo Dock without
are
Components" for details
, use the
En
47