Onkyo HT-S5400 Instruction Manual page 38

Dolby Settings
■
PLIIx Music (2ch Input)
These settings apply to only 2-channel stereo sources.
If you're not using any surround back speakers, these
settings apply to Dolby Pro Logic II, not Dolby Pro Logic
IIx.
Panorama
On
Off
Turn this setting on to broaden the width of the front
stereo image when using the Dolby Pro Logic IIx Music
listening mode.
Dimension
–3 to 0 to +3
With this setting, you can move the sound field forward or
backward when using the Dolby Pro Logic IIx Music
listening mode. Higher settings move the sound field
backward. Lower settings move it forward.
If the stereo image feels too wide, or there's too much
surround sound, move the sound field forward to improve
the balance. Conversely, if the stereo image feels like it's
in mono, or there's not enough surround sound, move it
backward.
Center Width
0 to 3 to 7
With this setting, you can adjust the width of the sound
from the center speaker when using the Dolby Pro Logic
IIx Music listening mode. Normally, if you're using a
center speaker, the center channel sound is output from
only the center speaker. (If you're not using a center
speaker, the center channel sound will be distributed to the
front left and right speakers to create a phantom center).
This setting controls the front left, right, and center mix,
allowing you to adjust the weight of the center channel
sound.
PLIIz Height Gain
Low
Mid
High
The Height Gain Control in Dolby Pro Logic IIz enables
the listener to select how much gain is applied to the front
high speakers. There are three settings, "Low", "Mid" and
"High", and the front high speakers are accentuated in that
order. While "Mid" is the default listening setting, the
listener may adjust the Height Gain Control to their
personal preference.
Note
• If the "Front High" settings is set to "None"
setting cannot be selected.
En
38
■
Dolby EX
This setting determines how Dolby EX encoded signals
are handled. This setting is unavailable if no surround
back speakers are connected. This setting is effective with
Dolby Digital, Dolby Digital Plus and Dolby TrueHD
only.
Dolby EX
Auto:
If the source signal contains a Dolby EX flag, the
Dolby EX listening mode is used.
Manual:
You can select any available listening mode.
Note
• If the "Surround Back" Setting is set to "None"
this setting cannot be selected.
• If the "Front High" setting is set to other than "None", this
setting is fixed at "Manual"
DTS Setting
■
Neo:6 Music
Center Image
0 to 2 to 5
The DTS Neo:6 Music listening mode creates 6-channel
surround sound from 2-channel stereo sources. With this
setting, you can specify by how much the front left and
right channel output is attenuated in order to create the
center channel.
Setting a value "0" in the middle is set to hear a sound.
Sound is spread in left and right (the outside) so that the
set value is made big. Please adjust by liking.
Theater-Dimensional Setting
■
Theater-Dimensional
Listening Angle
Wide:
Select if the listening angle is 40 degrees.
Narrow:
Select if the listening angle is 20 degrees.
With this setting, you can optimize the Theater-
Dimensional listening mode by specifying the angle of the
front left and right speakers relative to the listening
position. Ideally, the front left and right speakers should
be equidistant from the listening position and at an angle
close to one of the two available settings.
page 36), this
(➔
(➔ page 36).
Front left Front right
speaker speaker
20°/40°
(➔ page 36),