REV.-A
4.2.5.12 Main and Base Frame Removal
Step 1: Remove the printer mechanism (Refer to Section 4.2.5.1.).
Step 2: Remove the printhead (Refer to Section 4.2.5.2.).
Step 3: Remove the carriage motor (Refer to Section 4.2.5.4.).
Step 4: Remove the belt-driven pulley (Refer to Section 4.2.5.5.).
Step5: Remove the paper feed motor (Refer to Section 4.3.5.7).
Step 6: Cut wire clamps fix cables to the base frame.
FX-850
Wire Clamp
Wire Clamp
FX-105O
Figure 4-33.
Wire Clamp Positions
Step 7. Remove the home position sensor and plunger cables from the base frame.
Figure 4-34, Cable Positions on the Base Frame
4-25