4.2.5.4 Carriage Motor Removal
Step 1: Remove the printer mechanism (Refer to Section 4.2.5. 1.).
Step 2: Remove the carriage motor wires from the wire holder.
Step 3: Remove the timing-belt tension spring.
Step 4: Remove the two CPS (0) (3 X 10) screws securing the carriage motor mounting plate to base
frame via carriage motor mounting bush.
Step 5: Remove the carriage motor mounting plate together with the carriage motor.
Timing Belt
Tension SpI
Carriage Mot
Mounting Pla
Base
Fra
Step 6: Remove the four CPS(0) (3 X 6) screws on the rear side of the carriage motor mounting plate,
which secure the carriage motor.
Figure 4-20. Carriage Motor Removal (1)
Carriage Motor
Mounting Plate
Figure 4-21. Carriage Motor
4 - 1 6
Carriage Motor
Removal (2)