Paper End Detection - Epson LQ 1050 - B/W Dot-matrix Printer Technical Manual

1.10 PAPER END DETECTION

The paper end is detected by the PE
by lighting the lamp on the control panel and ringing the buzzer. The printer sets the parallel interface
as shown below, and enters the
signals
BUSY signal: HIGH
PE signal: HIGH
. ERROR signal: LOW
After the paper end is detected, load a new sheet and press the ON LINE switch so that the printer enters
the ON
LINE mode. Figure 1-10 shows the paper end detection position.
sensor. When the paper end is detected, the printer indicates it
OFF LINE mode.
Paper End Detection Posltlon
Approx.
59. 9mm
ABC
I
Fig. 1-10. Paper End Detection Position
1-24