Paper Tension Unit Disassembly - Epson LQ 1050 - B/W Dot-matrix Printer Technical Manual

4.2.5.20 Paper Tension Unit Disassembly

This section describes the removal of the paper tension roller assembly. Since disassembled parts can
be reassembled by using these procedures in reverse order, the assembly procedures have been
omitted.
Step 1: Remove the RE (4) on the paper tension roller shaft at the inside of the paper tension frame
R.
Step 2: Remove the RE (4) on the paper tension roller shaft at the outside of the paper tension frame
L.
Remove the CPS(0) (3 X 10) screw securing paper tension frame Lto paper tension base frame.
Step 3:
Step 4: Remove the HNO (4) nut.
Step 5: Disconnect the paper tension shaft holder from the paper tension frame R by sliding it toward
the outside, then remove it.
RE (4)
\
CPS (o)
(3 x 10)4
Figure 4-52. Paper Tension Roller Assembly
\
Removal
4-36
RE (4)
\
Shaft Holder
Paper Tension Frame R