Antenna Setup - Digital - Sharp LC-32HT3U Operation Manual

Basic adjustment settings
Channel memory setting
Press MENU to display the MENU screen, and
1
then press c / d to select "Setup".
Press a / b to select "CH Setup", and then
2
press ENTER.
• If you already set the Secret No., input the 4-digit
secret number here. See page 62 for setting a
secret number.
Press a / b to select "CH Memory", and then
3
press ENTER.
Press a / b to select ANALOG (Air), ANALOG
4
(Cable), DIGITAL (Air) or DIGITAL (Cable), and
then press ENTER.
When viewing ANALOG broadcasts:
5
1 Press c / d to select the channel to skip,
and then press b to move down.
2 Press c / d to select "On", and then press
ENTER.
When viewing DIGITAL broadcasts:
1 Press a / b to select the channel to skip,
and then press c / d to select "On".
• On: Skips channels. (Channel selection disabled using CH
r / s .)
• Off: Does not skip channels. (Channel selection enabled
using CH r / s .)
Press MENU to exit.
6
NOTE
• Make sure what kind of connection is made with your TV.
• "CH Memory" is not available in the MASTER mode.

Antenna Setup - DIGITAL

In order to receive digital air broadcasts, you need
a digital broadcast antenna. You can confi rm the
antenna confi guration through the "Antenna Setup -
DIGITAL" screen.
If necessary, adjust the direction of the antenna to
obtain the maximum signal strength.
Signal Strength
Press MENU to display the MENU screen, and
1
then press c / d to select "Setup".
Press a / b to select "Antenna Setup -
2
DIGITAL", and then press ENTER.
Press a / b to select "Signal Strength".
3
• The signal strength of DIGITAL channel is
Press MENU to exit.
4
Channel Strength
The channel signal strength can also be checked
separately.
Repeat steps 1 and 2 in Signal Strength in
1
Antenna Setup - DIGITAL.
Press a / b to select "Channel Strength", and
2
then press ENTER.
Input the 2-digit channel number to check the
3
signal strength of the selected channel.
• Make sure the signal is strong enough for each
PPV TV Press MENU to exit.
4
NORMAL TV
NOTE
• This function is available for DIGITAL (Air) only.
displayed. The signal information is based on the
current channel.
Signal Strength
Channel Strength
Signal Strength
Current 0
channel.
Signal Strength
1 2
Channel Strength
Signal Strength
Current 0
Max 0
CH
Max 0
45