Label Input; Ch Re-Map - Sharp LC-32HT3U Operation Manual

Quick setup for ONCOMMAND users

Label Input

You can assign a label to each input source and
channel.
Press MENU and the MENU screen displays.
1
Press c / d to select "PPV TV".
2
Press a / b to select "Label Input", and then
3
press ENTER.
Press a / b to select the desired input source,
4
and then press ENTER
For "INPUT 1" to "INPUT 6":
5
1 Press a / b / c / d and ENTER to select
each character of the new name for the
input source.
2 Press a / b / c / d to select "END", and
then press ENTER to complete the
labeling.
For "TV":
1 Press c / d to select "Air" or "Cable", and
then press b to move down.
2 Press c / d to select the channel number
you want to label, and then press b to
move down.
• The channel number is based on the physical
number, and it may be different from the
displayed channel number specifi ed by the
hotel server.
3 Select "Select", and then press ENTER.
4 Press a / b / c / d and ENTER to select
each character of the new name for the
channel.
5 Press a / b / c / d to select "END", and
then press ENTER to complete the
labeling.
Press MENU to exit.
6
NOTE
• Depending on the system version, you can assign a label
using the hotel server.
• When you change the input name for "INPUT 1" through
"INPUT 6" in the Label Input setting, the input name
you have labeled will not change even if you change the
Language setting.

CH Re-Map

Sets the channel order (logical channel) to your
preferred order.
Press MENU and the MENU screen displays
1
Press c / d to select "PPV TV".
2
Press a / b to select "CH Re-Map", and then
3
press ENTER.
Press a / b to select "CH Set", and then press
4
ENTER.
Press a / b / c / d to select the Logical CH you
5
want to set, and then press ENTER.
Press a / b to select "ANALOG" , "DIGITAL"
6
or the desired input source, and then press
ENTER.
When you select "ANALOG" or "DIGITAL",
input the channel number by using 0 – 9, and
then press ENTER.
• Select "Reset" for resetting the channel to the
factory preset value.
• When you input digital channels with a single
number after the dot, input 0 after the dot.
(e. g., Channel 22.1):
Press 0 s 2 s 2 s 0 s 1 s ENTER
Repeat the steps 5 and 6 until all desired logical
7
channels are set.
Press MENU to exit.
8
NOTE
• For resetting all logical channels to the factory preset
values, select "CH Reset All" in step 4, press c / d to
select "Yes", and then press ENTER.
15