Shelf Supports; Removing The Shelf Supports; Installing The Shelf Supports - Electrolux EOD5700AAK User Manual

To support this self-cleaning process
heat the appliance without any food
regularly:
1. Remove the accessories from the ap-
pliance.
2.
Touch again and again until the
display shows "Cata" and the dura-
tion of the cleaning procedure (1
hour). You cannot set the duration,
but you can use the End function to
delay the start of the cleaning proce-
dure.
3. An acoustic signal sounds after the
time ends. The appliance deactivates.
4.
Touch a sensor field or open the oven
door to stop the acoustic signal.

11.2 Shelf supports

Removing the shelf supports

1

Installing the shelf supports

Install the shelf supports in the opposite
sequence.
2
5. Clean the bottom of the appliance
with a soft and moist sponge.
WARNING!
Do not clean the catalytic surface
with oven sprays, abrasive clean-
ing agents, soaps or other clean-
ing agents. There is a risk of dam-
age to the catalytic surface.
The discolouration of the catalytic
surface has no effect on the cata-
lytic properties.
During the catalytic cleaning the
oven lamp is on.
You can remove the shelf supports to
clean the side walls.
1. Pull the front of the shelf support
away from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
Valid for telescopic runners:
The retaining pins on the tele-
scopic runners must point to the
front.
11.3 Lamp
WARNING!
There is a risk of electrical shock.
The lamp and the lamp glass cov-
er can be hot.
ENGLISH 27