Switch Parameters; Configure Switch Parameters Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Installing and Configuring the Edge Switch 2/24
The switch must be offline to change Preferred Domain ID and other operating
parameters.
1. Ensure that the switch is set offline. For instructions, see
2. Choose Configure > Operating Parameters > Switch Parameters. The
Figure 18: Configure Switch Parameters dialog box
Note:
defaults. The only exception is the Preferred Domain ID. Change this value if the switch
will participate in a multiswitch fabric.
3. Use information in the
4. After you change settings, click Activate.
5. Set the switch online. For instructions, see

Switch Parameters

Configure the following parameters as required by your fabric.
68
Offline" on page 66.
Caution: Setting the switch offline terminates all Fibre Channel connections.
Configure Switch Parameters dialog box displays
Ordinarily, you do not need to change values in this dialog box from their
follows, to change settings as required for parameters in this dialog box.
page 66.
"Switch Parameters" on page 68" section, which
"Set the Switch
"Set the Switch
(Figure 18).
Online" on
Edge Switch 2/24 Installation Guide