Using the Embedded Web
Server
If an HAFM appliance is not available, or is not used to manage the switch, use
the Embedded Web Server (EWS) interface to configure the Edge Switch 2/24.
Selectively perform the following configuration tasks according to your
installation requirements:
Note:
interface. For additional information on configuring more advanced features using
EWS, see the online EWS help or the
Guide
Edge Switch 2/24 Installation Guide
Configure Switch
Ports, page 98
Configure Switch and Fabric
Configure Network
Configure SNMP Trap Message
Enable or Disable the
Configure User
Rights, page 111
This chapter describes the initial setup of the Edge Switch 2/24 using the EWS
.
Parameters, page 102
Information, page 106
Recipients, page 108
CLI, page 110
HP StorageWorks Embedded Web Server User
4
95