Disconnect Now Dialog Box; Save Session Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

10. Change the IP address, subnet mask, and gateway address as directed by the
11. Choose File > Exit to close the HyperTerminal window. A message box
Figure 11: Disconnect Now dialog box
12. Click Yes. A message box displays
Figure 12: Save Session dialog box
13. Click No to exit and close the HyperTerminal dialog box.
14. Power off the maintenance terminal:
15. Disconnect the RS-232 null modem cable from the switch and the
Edge Switch 2/24 Installation Guide
customer's network administrator. To change switch network addresses, enter
the following at the C> prompt:.
ipconfig xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
The IP address is always xxx.xxx.xxx.xxx, the subnet mask is always
yyy.yyy.yyy.yyy, and the gateway address is always
zzz.zzz.zzz.zzz, where the octets xxx, yyy, and zzz are decimals
from zero through 255. If a network address is to remain unchanged, enter the
current address in the respective field.
When the new network addresses are configured at the switch, the message
Request completed OK displays at the bottom of the
Edge Switch 2/24 — HyperTerminal window.
displays (Figure 11).
a. Choose Start > Shut Down. The Shut Down Windows dialog box
displays.
b. Choose Shut down the Computer and click Yes to power off the PC.
maintenance terminal. Replace the protective plate over the maintenance port.
Installing and Configuring the Edge Switch 2/24
(Figure 12).
57