Lan-Connect The Switch - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Installing and Configuring the Edge Switch 2/24

LAN-Connect the Switch

Connect the switch to the Ethernet LAN segment or the HP-supplied Ethernet hub
as follows:
1. Connect one end of the Ethernet patch cable (supplied with the switch) to the
2. Connect the remaining end of the Ethernet cable to the LAN as follows:
3. Perform one of the following steps:
58
RJ-45 connector (labeled 10/100) on the left front of the chassis.
a. If the switch is installed on a LAN segment, connect the cable to the LAN
as directed by the customer's network administrator.
b. If the switch is installed on the HP-supplied Ethernet hub, connect the
cable to any available port on the hub.
If an HAFM appliance is delivered and available, go to
HAFM Appliance" on page 59.
If an HAFM appliance is not available and the switch is managed through
the EWS interface, attach the Ethernet LAN segment to an Internet
connection and go to "Using the Embedded Web
"Configure the
Server" on page 95.
Edge Switch 2/24 Installation Guide