Closing The Blade Server Cover - IBM QS22 - BladeCenter - 0793 Service Manual

Figure 24. Installing the front bezel assembly
Complete the following steps to install the blade server front bezel assembly:
1. Read the safety information beginning on page vii and "Installation guidelines"
2. Connect the control panel cable to the control panel connector on the system
3. Carefully slide the front bezel assembly onto the blade server, as shown in
Note: Make sure that you do not pinch any cables when you reinstall the front

Closing the blade server cover

Important: The blade server cannot be inserted into the BladeCenter unit until the
cover is installed and closed or an expansion unit is installed. Do not attempt to
override this protection.
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade cover before installing the blade server.
52
BladeCenter QS22 Type 0793: Problem Determination and Service Guide
Blade cover
Cover release
Bezel release
on page 29.
board assembly.
Figure 24, until it clicks into place.
bezel assembly.
Cover release
Bezel release
Control-Panel
Cable
Bezel assembly
Control-Panel
Connector