Table of Contents
Advertisement
4. Locate the flash drive retention clip and connector on the system board.
Tab
Flash drive
Connector
Retention clip
Figure 9. Fitting the modular flash drive
5. Locate the connector on the back of the modular flash drive.
6. Carefully align the modular flash drive with the retention clip and connector on
7. Gently press the modular flash drive into position.
8. If applicable, reinstall the high-speed expansion card.
If you have other options to install or remove, do so now. Otherwise, go to
"Finishing the installation" on page 50.
Removing the optional modular flash drive
Complete the following steps to remove the modular flash drive:
1. Read the safety information beginning on page vii and "Installation guidelines"
2. If applicable, shut down the operating system, turn off the blade server, and
3. Open the blade server cover. See "Opening and removing the blade server
4. Locate the modular flash drive on the system board. The modular flash drive
the system board. Ensure the orientation of the connector on the modular flash
drive matches the connector on the system board.
on page 29.
remove the blade server from the BladeCenter unit. See "Removing the blade
server from the BladeCenter unit" on page 30.
cover" on page 31.
can be underneath a high-speed expansion card.
Chapter 4. Installing and removing replaceable units
35
Advertisement
Table of Contents
Troubleshooting
