Blade Server Ethernet Controller Enumeration - IBM QS22 - BladeCenter - 0793 Service Manual

Note: The error message shown above is correct as it refers to an adapter not

Blade server Ethernet controller enumeration

The enumeration of the Ethernet controller or controller ports in a blade server is
operating system dependent. You can verify the Ethernet controller or controller port
designations that a blade server uses through your operating system settings.
The routing of an Ethernet controller or controller port to a particular BladeCenter
unit I/O bay depends on the type of Ethernet controller that is installed. You can
verify which Ethernet-controller port is routed to which I/O bay by using the
following test:
1. Install only one Ethernet switch module or pass-thru module, in I/O bay 1.
2. Make sure that the ports on the switch module or pass-thru module are enabled
3. Enable only one of the Ethernet-controller ports on the blade server. Note the
4. Ping an external computer on the network connected to the Ethernet switch
Communications from optional I/O expansion cards are routed to I/O bays 3 and 4.
If you have installed an I/O expansion card on the blade server you can verify
which controller port on an expansion card is routed to which I/O bay by performing
the same test, using a controller on the expansion card and a compatible switch
module or pass-thru module in I/O bay 3 or 4.
[root@c4b14 brcm-2.0.3-ppc]# ./ brcm_fw_nic_2.0.3-e-1_rhel5_cell.sh -u
IBM Ethernet Firmware Update Tool, Version 1.0.2
Warning. No Broadcom NetXtreme II adapters found.
ADAPTER MAC BOOT
------------------- ----
001A640E030C (5704s) 3.21
001A640E030D (5704s) NA
Updating Broadcom NetXtreme adapters.
Updating 001A640E030C using file 16A8bc.bin
Updating 001A640E030C using file 16A8ipmi.bin
Error! Firmware not detected on device 001A640E030D.
Warning. No Broadcom NetXtreme II adapters found.
ADAPTER MAC BOOT
------------------- ----
001A640E030C (5704s) 3.38
001A640E030D (5704s) NA
One or more errors occurred during the firmware update process. See /var
available on QS22.
(Switch Tasks → Management → Advanced Switch Management in the
BladeCenter Management Module Web interface).
designation that the blade server operating system has for the controller port.
module. If you can ping the external computer, the Ethernet-controller port that
you enabled is associated with the switch module in I/O bay 1. The other
Ethernet-controller port in the blade server is associated with the switch module
in I/O bay 2.
IPMI ASF PXE UMP
---- --- --- ---
2.20 NA NA NA
NA NA NA NA
---> Update successful
---> Update successful
IPMI ASF PXE UMP
---- --- --- ---
2.47 NA NA NA
NA NA NA NA
Chapter 2. Configuring the blade server
25