Installing An Optional High-Speed Expansion Card - IBM QS22 - BladeCenter - 0793 Service Manual

Tab
Flash drive
Connector
Retention clip
Figure 10. Removing the modular flash drive
5. Locate the tab on the modular flash drive. See Figure 10.
6. Using the tab, carefully lift the modular flash drive away from the retention clip
7. If applicable, reinstall the high-speed expansion card.
If you have other options to install or remove, do so now. Otherwise, go to
"Finishing the installation" on page 50.

Installing an optional high-speed expansion card

You can connect a high-speed expansion card, for example an InfiniBand card, to
the high-speed connector on the system board. Use the two expansion card locator
pins to assist with fitting the card. If your card has a ball socket, use the socket to
lock the card in place.
36
BladeCenter QS22 Type 0793: Problem Determination and Service Guide
If the modular flash drive is blocked by a high-speed expansion card, you must
remove the high-speed expansion card before removing the modular flash drive.
See "Removing an optional high-speed expansion card" on page 38.
and connector on the system board.