IBM QS22 - BladeCenter - 0793 Service Manual page 123

Table 21. BMC firmware messages (continued)
Message Severity
Drive bay 1, hard Error
drive (ModFD Error)
fault
FW/BIOS, firmware Error
progress (Pri FW
Corrupt) system
board hang
FW/BIOS, firmware Error
progress (Pri FW
Corrupt) no system
memory
FW/BIOS, firmware Error
progress (Pri FW
Corrupt) no usable
system memory
Memory device x Error
(DIMM x
uncorrectable ECC
memory
errorwherex is the
number of the
affected DIMM.
Memory device x Error
(DIMM x memory
disabledwherex is
the number of the
affected DIMM.
Event
A fault has occurred with the
modular flash drive.
Firmware progress events
An error has occurred on the
system board during boot.
No system memory was found
System memory was found,
but is unusable
Memory subsystem
A system DIMM or an I/O
buffer DIMM has returned an
uncorrectable error.
A system DIMM or an I/O
buffer DIMM has returned an
uncorrectable error.
Automatic Action by
BMC
Blade reboots
Blade does not power on
Blade does not power on
The affected memory
channel is disabled. If the
error concerns and I/O
buffer DIMM, both I/O
buffer DIMMs are
disabled.
The affected memory
channel is disabled. If the
error concerns and I/O
buffer DIMM, both I/O
buffer DIMMs are
disabled.
Chapter 5. Diagnostics and troubleshooting
Action required by
user
Remove and reseat
the modular flash
drive. Reboot.If the
error condition
continues, replace the
modular flash drive
with a similar unit and
reboot.If this does not
correct the problem,
contact IBM service.
If the error persists,
contact IBM service.
Add system memory,
or reseat existing
system memory.
Reboot.
Check supported
memory
configurations. See
"Adding or changing
system memory" on
page 39 for further
information.
Replace the affected
DIMM. If the problem
continues, contact
IBM service.
105