Adding Fru Information - IBM QS22 - BladeCenter - 0793 Service Manual

PowerPC Firmware
Version QD0123000
SLOF-SMS 1.1 (c) Copyright IBM Corp. 2007 All rights reserved.
--------------------------------------------------------------------------------
FRU Information
Machine Type and Model: 079338x
Machine Serial Number: ABCDEFG
Universal Unique ID: 12345678-1234-1234-1234-123456789ABC
--------------------------------------------------------------------------------
Navigation Keys:
M = return to Main Menu
ESC key = return to previous screen
--------------------------------------------------------------------------------
Select Navigation key :
Note: You cannot change the FRU information from this screen, only view it.
Adding FRU information: When you replace a FRU details are not recorded in
the VPD. You must enter them manually through SMS.
When the system firmware detects an FRU replacement part during boot the
process stops to allow you to enter the machine type or model and serial number.
Boot does not continue until the information is provided.
To enter new FRU information, complete the following steps:
1. Using a Telnet or SSH client, connect to the Advanced Management Module
external Ethernet interface IP address.
2. When prompted, enter a valid user ID and password. The default management
module user ID is USERID, and the default password is PASSW0RD, where the
0 is a zero.
Note: The userid and password may have been changed. If so, check with the
system administrator for a valid user id and password.
3. Power cycle the blade and start an SOL console by using the power -cycle -c
command. See "Using the SMS utility program" on page 11 for further
information.
4. The following screen appears:
X = eXit System Management Services
Chapter 2. Configuring the blade server
13