Installing A Ciov-Form-Factor Expansion Card - IBM 8038 Installation And User Manual

5. Touch the static-protective package that contains the expansion card to any
6. Locate the CIOv expansion connector (see "Blade server connectors" on page
7. Using your fingers, move the retaining clips away from the CIOv card; then, lift

Installing a CIOv-form-factor expansion card

Use these instructions to install a CIOv-form-factor expansion card in the blade
server.
The blade server supports a vertical-combination-I/O (CIOv) expansion card and a
horizontal-combination-form-factor (CFFh) expansion card. The following
illustration shows the location and installation of a CIOv expansion card.
Attention: If the expansion card is not running at the speed supported by the
card, you can change the maximum speed of the PCIe bus in the Setup Utility by
selecting System Settings and Devices and I/O Ports.
To install a CIOv expansion card, complete the following steps:
40
BladeCenter HS23E Type 8038 and 8039: Installation and User's Guide
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component; then, remove the expansion card from
the package.
15).
the card out of the connector.
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
page 17.