Completing The Installation; Installing The Blade Server Bezel Assembly - IBM HS40 - BladeCenter - 8839 Maintenance And Troubleshooting Manual

10. Turn on the blade server.
11. Start the blade server Configuration/Setup Utility program and set configuration

Completing the installation

To complete the installation, perform the following tasks. Instructions for each task
are in the following sections.
1. Reinstall the blade server bezel assembly, if you removed it (see "Installing the
2. Close the blade server cover, unless you installed the SCSI storage expansion
3. Reinstall the blade server into the BladeCenter unit (see "Installing the blade
4. Turn on the blade server (see "Turning on the blade server" on page 6).
Note: Reinstall the bezel assembly on the BladeCenter T unit after you have
5. For certain options, run the blade server Configuration/Setup Utility program
Note: If you have just connected the power cords of your BladeCenter unit to

Installing the blade server bezel assembly

Complete the following steps to install the blade server bezel assembly.
62
BladeCenter HS40 Type 8839: Hardware Maintenance Manual and Troubleshooting Guide
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
9. Reinsert the blade server into the bay in the BladeCenter unit.
parameters as needed (see "Using the Configuration/Setup Utility program" on
page 11 for information).
blade server bezel assembly").
Attention: To help ensure proper cooling and system reliability, the air baffle
must be correctly positioned and fully seated.
unit option (see "Closing the blade server cover" on page 63).
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
server in the BladeCenter unit" on page 65).
finished turning on the blades. However, if you installed an option such as a
PCI I/O Expansion Unit with PCI adapters that require cables, you will not be
able to install the bezel assembly, which contains an air filter for the
BladeCenter T unit. If you cannot install the bezel assembly, a filter must be
provided on the rack. See the IBM Eserver BladeCenter T Planning and
Installation Guide for information about installing an air filter on the rack (you
can obtain the planning guide from http://www.ibm.com/pc/support/).
(see "Updating your blade server configuration" on page 67).
electrical outlets, you will have to wait until the power-on LED on the blade
server flashes slowly before pressing the power-control button on a blade
server.