Installing Your Operating System Without Serverguide; Using The Pxe Boot Agent Utility Program - IBM HS40 - BladeCenter - 8839 Maintenance And Troubleshooting Manual

Note: Features and functions can vary slightly with different versions of the
1. After you have completed the setup process, the operating-system installation
2. The ServerGuide program stores information about the blade server model,
3. The ServerGuide program presents operating-system partition options that are
4. The ServerGuide program prompts you to insert your operating-system CD and

Installing your operating system without ServerGuide

If you have already configured the blade server hardware and you decide not to use
the ServerGuide program to install your operating system, complete the following
steps to download the latest operating-system installation instructions from the IBM
Support Web page:
1. Go to http://www.ibm.com/pc/support/.
2. In the Download section, click Downloads & drivers.
3. On the "Downloads and drivers" page, in the Brand field, select Servers.
4. In the Family field, select BladeCenter HS40.
5. Click Continue.
6. In the View by document type field, select OS installation.
7. Select the instructions for your operating system.

Using the PXE boot agent utility program

This program is a built-in, menu-driven configuration utility program that you can
use to select the boot protocol and other boot options and select a power
management option.
Note: The remote program load (RPL) selection for the boot protocol option is not
Complete the following steps to start the PXE boot agent utility program:
1. Turn on the server.
2. When the Broadcom NetXtreme Boot Agent vX.X.X prompt appears, press
3. Use the arrow keys and press Enter to select a choice from the menu.
4. Follow the instructions on the screen to change the settings of the selected
16
BladeCenter HS40 Type 8839: Hardware Maintenance Manual and Troubleshooting Guide
ServerGuide program.
program starts. (You will need your operating-system CD to complete the
installation.)
service processor, hard disk drive controllers, and network adapters. Then, the
program checks the CD for newer device drivers. This information is stored and
then passed to the operating-system installation program.
based on your operating-system selection and the installed hard disk drives.
restart the server. At this point, the installation program for the operating system
takes control to complete the installation. The BladeCenter CD-ROM drive must
be associated with the blade server before you perform this step.
supported for this server.
Ctrl+S. You have 2 seconds (by default) to press Ctrl+S after the prompt
appears.
If the PXE setup prompt is not displayed, use the Configuration/Setup Utility
program to enable the Ethernet PXE/DHCP option.
items; then, press Enter.