Post Error Codes - IBM HS40 - BladeCenter - 8839 Maintenance And Troubleshooting Manual

POST error codes

The following table lists error codes that might be sent to the management module
for error logging as BMC pass-through error entries for the management module
system-error log (SEL).
Note: The syntax of error logging between the management module and the SEL
In the following error codes, X can be any number or letter.
Note: See Chapter 7, "Parts listing, Type 8839," on page 105 to determine which components should be replaced by
a field service technician.
Error code/symptom
0000
(Timer error)
0005
(CMOS checksum bad loading defaults)
0012
(CMOS date/time not set)
0040
(Refresh timer test failed)
0044
(DMA controller error)
0045
(DMA-1 error)
0046
(DMA-2 error)
004C
(Keyboard/interface error)
004D
(Primary master hard disk error)
004F
(Secondary master hard disk error)
0055
(Primary master drive - ATAPI
incompatible)
0057
(Secondary master drive - ATAPI
incompatible)
005D
(ATA SMART failure error (dynamic string))
might be different. Local SEL error codes might differ from the SEL entries
logged by the management module for identical event types.
FRU/action
1. Run diagnostics.
2. Battery.
3. I/O board.
Information only; no action required.
Run the Configuration/Setup Utility program, and set the date and
time.
1. I/O board
2. Processor board
I/O board
I/O board
I/O board
I/O board
1. Reset primary hard disk.
2. Run diagnostics.
3. Primary hard disk.
4. I/O board.
1. Reset secondary hard disk.
2. Run diagnostics.
3. Secondary hard disk.
4. I/O board.
Primary master hard disk drive
Secondary master hard disk drive
ATA drive
Chapter 6. Symptom-to-FRU index
79