IBM HS40 - BladeCenter - 8839 Maintenance And Troubleshooting Manual page 60

Important:
The following illustration shows how to install an I/O expansion card on the blade
server. The same procedure is used to install an expansion card in either I/O
expansion card location; however, the illustration shows installing an expansion card
only in I/O expansion card location 2.
Screws
Complete the following steps to install an I/O expansion card:
1. Review the safety information beginning on page 109 and "Installation
2. Shut down the operating system, turn off the blade server, and remove the
3. Carefully lay the blade server on a flat, nonconductive surface.
4. Open the blade server cover (see "Opening the blade server cover" on page 40
5. Remove the two screws near connector J8H1 (or connector J4H1, if you are
6. Install the I/O expansion card:
50
BladeCenter HS40 Type 8839: Hardware Maintenance Manual and Troubleshooting Guide
If you are installing only one I/O expansion card in the blade server, it must
be installed in I/O expansion card location 2.
Screws
guidelines" on page 33.
blade server from the BladeCenter unit (see "Removing the blade server from
the BladeCenter unit" on page 39 for information).
for instructions), and lift it off the blade server.
installing an I/O expansion card in I/O expansion location 1) that secure the I/O
board to the chassis, as shown in the illustration.
a. Install the I/O expansion card tray. Secure the tray to the I/O board with the
four long screws from the option kit, as shown in the illustration.
b. Orient the I/O expansion card as shown in the illustration.
c. Slide the notch in the narrow end of the card into the raised hook on the
tray; then, gently pivot the wide end of the card into the I/O expansion card
connectors, as shown in the illustration.
I/O expansion card
Screws
I/O expansion
card tray