IBM HS40 - BladeCenter - 8839 Maintenance And Troubleshooting Manual page 90

Note: See Chapter 7, "Parts listing, Type 8839," on page 105 to determine which components should be replaced by
a field service technician.
Error code/symptom
196
(Processor cache mismatch detected)
198
(Processor speed mismatch detected)
289
(Non-matching or missing DIMMs, user
has not installed DIMMs correctly, or
DIMM disabled by POST or user)
8120
(Microprocessor 1 thermal trip error)
8121
(Microprocessor 2 thermal trip error)
8122
(Microprocessor 3 thermal trip error)
8123
(Microprocessor 4 thermal trip error)
8130
(Microprocessor 1 disabled)
8131
(Microprocessor 2 disabled)
8133
(Microprocessor 3 disabled)
8134
(Microprocessor 4 disabled)
8140
(Microprocessor 1 failed FRB-3 timer)
80
BladeCenter HS40 Type 8839: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
1. Microprocessor
2. Processor board
1. Microprocessor
2. Processor board
1. Run the Configuration/Setup Utility program.
2. Disabled DIMM.
3. System board
1. Check cooling.
2. Replace blowers if needed.
3. Run the Configuration/Setup Utility program, and enable the
processor retest.
4. Microprocessor 1.
1. Check cooling.
2. Replace blowers if needed.
3. Run the Configuration/Setup Utility program, and enable the
processor retest.
4. Microprocessor 2.
1. Check cooling.
2. Replace blowers if needed.
3. Run the Configuration/Setup Utility program, and enable the
processor retest.
4. Microprocessor 3.
1. Check cooling.
2. Replace blowers if needed.
3. Run the Configuration/Setup Utility program, and enable the
processor retest.
4. Microprocessor 4.
1. Run the Configuration/Setup Utility program, and enable the
processor retest.
2. Microprocessor 1.
1. Run the Configuration/Setup Utility program, and enable the
processor retest.
2. Microprocessor 2.
1. Run the Configuration/Setup Utility program, and enable the
processor retest.
2. Microprocessor 3.
1. Run the Configuration/Setup Utility program, and enable the
processor retest.
2. Microprocessor 4.
1. Run the Configuration/Setup Utility program, and enable the
processor retest.
2. Microprocessor 1.