IBM HS40 - BladeCenter - 8839 Maintenance And Troubleshooting Manual page 70

Batteries and accumulators that contain heavy metals must not be disposed of with
normal domestic waste. They will be taken back free of charge by the manufacturer,
distributor, or representative, to be recycled or disposed of in a proper manner.
To order replacement batteries, call 1-800-426-7378 within the United States, and
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada,
call your IBM reseller or IBM marketing representative.
Note: After you replace the battery, you must reconfigure your blade server and
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Complete the following steps to replace the battery:
60
BladeCenter HS40 Type 8839: Hardware Maintenance Manual and Troubleshooting Guide
reset the system date and time.
1. Review the safety information beginning on page 109 and "Installation
guidelines" on page 33.
2. Follow any special handling and installation instructions supplied with the
battery.
3. Turn off the blade server and remove the blade from the BladeCenter unit (see
"Removing the blade server from the BladeCenter unit" on page 39 for
instructions).
4. Open the blade server cover (see "Opening the blade server cover" on page
40 for instructions) and lift it off the blade server.