Chapter 8 When A Problem Occurs; Error Messages - Kyocera KM-2030 Instruction Handbook Manual

CHAPTER 8 WHEN A PROBLEM OCCURS

1. Error messages

When any of the messages listed in the table below appear on the message display, take the corrective action as instructed.
Message
"Close xxx cover."
"Add paper in drawer."
"Set drawer."
"Drawer inoperable. Call for service."
"Check paper size."
"Reposi ori. or change drawer."
"Exceeded copy quantity limit."
"Ready to copy. Add toner to resume copying."
"Add toner to resume copying."
"Call for service."
8-1
The cover indicated is open. Close the cover securely.
There is no paper in the drawer indicated. Load paper.
One of the drawers is not closed properly. Pull it out and push it back in all the
way.
The drawer currently in use is out of order and cannot be used. Contact your
service representative immediately. Continue copying using another drawer.
No paper that can be used in the selected mode is loaded. Check the paper.
The orientation of the original and the selected paper are different. Change the
orientation of the original. If the Start key is pressed, same-size copying will be
performed.
The number of copies reached the limit set in the copy management mode and
no more copies can be made. Clear the copy count from the management
mode.
There is not enough toner in the copier. Replace the toner cartridge immedi-
ately as only one copy can be made at a time.
There is not enough toner in the copier to make copies. Replace the toner
cartridge immediately.
Open and close the front cover. If the same message appears again, make a
note of the "C" and the number appearing with it, turn the main switch OFF (O),
and contact your service representative.
Action Page
3-1
6-1
3-5
3-5