CHAPTER 8 WHEN A PROBLEM OCCURS
2. When paper misfeeds
If a paper misfeed occurs, copying will stop. A misfeed message will appear and the misfeed location will be indicated on the message display.
"JAM" and a 2-digit number appear on the message display. The number indicates the paper misfeed location.
Remove the misfed paper by referring to "(3) Removal procedures" with the main switch turned ON (|).
(1) Misfeed location indicators
1 Misfeed in paper feed section
2 Misfeed in left cover (page 8-5)
3 Misfeed in DF <optional> (page 8-6)
4 Misfeed in duplex unit <optional> (page 8-6)
5 Misfeed in finisher <optional> (page 8-6)
(2) Cautions
WARNING
High voltage is present in the charger section. Take
sufficient care when working in this area, as there is a
danger of electrical shock.
CAUTION
The copier's fixing unit is extremely hot. Take sufficient
care when working in this area, as there is a danger of
getting burned.
* Do not reuse misfed paper.
* If paper is torn during removal, be sure to remove all loose scraps
from inside the copier, or they could cause misfeed later.
* After misfed paper has been removed, warm-up will begin. The
Misfeed indicator will turn off and the copier will return to the same
settings prior to the misfeed.
8-3
(3) Removal procedures
1 Misfeed in paper feed section
1
1
1
1
Misfeed in drawer (JAM 10, 11, 12, 13, 20, 21)
If the message "Paper misfeed in drawer. Remove paper." appears
with the misfeed location indicator shown in the illustration, a misfeed
has occurred in the drawer (or optional drawer). Remove the misfed
paper using the procedure given below.
1
Open the drawer.