Kyocera KM-2030 Instruction Handbook Manual page 22

CHAPTER 4 BASIC OPERATION
7
7. Setting the number of copies
Use the numeric keys to enter the desired number of copies on the
message display. Up to 250 copies can be set.
NOTE
• It is possible to lower the limit on the number of copies that can be
set at a time. (See "9 Copy limit" on page 6-13.)
8
8. Starting copying
Press the Start key. If the Start indicator is lit green and "Ready to
copy." is displayed on the message display, copying is possible.
9
9. At the end of copying
Finished copies are ejected onto the copy store section.
4-3
IMPORTANT
• Up to 250 sheets of standard paper (64 g/m
that the number of sheets that can be stored varies depending on
the condition of the paper used.
• When the job separator is installed, up to 150 sheets of standard
2
paper (64 g/m ) can be stored.
• When the finisher is installed, up to 100 sheets of standard paper
2
(64 g/m ) can be stored.
• If "Paper capacity exceeded. Remove paper from Inner." appears,
the copy store section is full. Remove paper from the copy store
section and press the Start key to resume copying.
If "Paper capacity exceeded. Remove paper from Job sep."
appears, the optional job separator is full. Copying will automatically
resume when paper is removed from the job separator.
• If copied sheets are not stored tidily due to curls or other paper
conditions, remove the paper from the drawer or multi-bypass used
and turn the paper upside down.
CAUTION
If the copier will not be used for a short period of time
(overnight, etc.), turn the main switch OFF (O). If it will not
be used for an extended period of time (vacations, etc.),
remove the power plug from the outlet for safety purposes
during the time the copier is not in use.
2
) can be stored. Note