Kyocera KM-2030 Instruction Handbook Manual page 46

Copy default setting
! Border width
Sets the initial value of the border erase width for the sheet erase or
book erase in the border erase mode (page 5-6).
@ Default drawer
Specifies the paper feed drawer to be selected automatically when
warm-up ends or when the Reset key is pressed (note that there may
be times when the default drawer may not be selected, such as when
the drawer is empty). Paper feed drawer 3 and 4 can be selected only
when the optional drawer is installed.
# Output form
Sets whether or not to perform sort copying (page 5-9) when the
optional DF is used (when originals are set in the DF).
$ Rotate sort
Sets whether the normal sort copy (page 5-9) or rotate sort copy (page
5-9) is used when the sort mode is selected.
• This setting is not displayed when the copier is equipped with the
optional finisher.
Content of copy default setting
CHAPTER 6 COPIER MANAGEMENT
Setting range
1/4", 1/2", 3/4"
1st pap. to
4th pap.
Sort: ON/
Sort: OFF
On/Off
Default setting Page
1/4" 6-13
1st pap. 6-13
Sort: OFF 6-13
Off 6-13
6-10