Table of Contents
Advertisement
Available languages
Available languages
Cycle
time
too short
Excessive
Weight
Hazard
Use two or more people
to move and install
dryer.
Failure
to do so can result
in back or other
injury.
•
Is the automatic
cycle ending early?
The load may not be contacting
the sensor strips, level
the dryer.
Change the dryness
level setting
on Sensor Dry Cycles.
Increasing
or decreasing
the
dryness level will change the amount
of drying time
in a cycle.
Lint on load
•
Is the lint screen clogged?
Clean lint screen. Check for air movement.
Stains
on load
or drum
•
Was dryer fabric softener properly
used?
Add dryer fabric
softener sheets at the beginning
of the cycle.
Fabric softener sheets added
to a partially
dried
load can stain your garments.
[])rum stains are caused by dyes in clothing
(usually
blue jeans). This will
not transfer to
other clothing.
Loads are wrinkled
•
Was the load removed
from dryer at the end of the cycle?
Select Custom
Refresh Cycle to tumble
the load with water and heat to help smooth out
wrinkles
from a load left in the dryer.
•
Was the dryer overloaded?
Dry smaller
loads that can tumble
freely. Smaller loads yield
best results with the Rapid
Refresh Small Load Cycle.
Results may also vary depending
on fabric type. This cycle is
best for reducing
wrinkles
and odors from loads consisting
of wrinkle-free
cotton,
cotton
polyester
blends,
common
knits and synthetics.
•
Loads are still wrinkled
following
Steam cycles?
Make sure water is connected
to the dryer. Check that water inlet hose is connected
to
both the faucet and dryer's water
inlet valve. Check that the water supply
is turned
on.
These cycles
are best for smoothing
out wrinkles
and reducing
odors from loads
consisting
of wrinkle-free
cotton,
cotton
polyester
blends,
common
knits and synthetic
garments.
NOTE:
Refer to garment
care label instructions.
Dry clean only garments
are not
recommended.
Odors
•
Have you recently
been painting,
staining
or varnishing
in the area where your dryer is
located?
If so, ventilate
the area. When
the odors or fumes are gone from the area, rewash and dry
the clothing.
•
Is the dryer being used for the first
time?
The new electric
heating
element
may have an odor. The odor will be gone after the first
cycle.
•
Is water
connected
to the dryer?
Check that water
inlet hose is connected
to both the faucet and dryer's water inlet valve.
Check that the water supply
is turned on.
•
lb remove
odors left in garments
after wearing,
select the Rapid Refresh Small Load cycle
for small loads of two to four garments.
This cycle
is best for reducing
wrinkles
and odors
from
loads consisting
of wrinkle-free
cotton,
cotton
polyester
blends,
common
knits and
synthetics.
Advertisement
Table of Contents
