PRODUCT MODEL NUMBERS
MED6000X, MED7000X, MED9000Y
Front view:
(686 mm)
38
/
"
1
8
(968 mm)
/
"*
3
4
(18 mm)
NOTE: Most installations require a minimum of 5" (127 mm)
clearance behind dryer for exhaust vent with elbow. See
"Venting Requirements."
Recommended Installation Spacing (Dryer Only):
5"
(127 mm)
(25 mm)
27"
3"
(76 mm)
18" min.
(457 mm)
3"
(76 mm)
1"
1"
(25 mm)
Electric Dryer
Side view:
Installation spacing for recessed area
or closet installation
All dimensions show recommended and minimum spacing
allowed.
48 in.
min.
2
Additional spacing should be considered for ease of
■
(310 cm
)
2
installation and servicing.
Additional clearances might be required for wall, door, floor
■
moldings, and dryer venting.
Additional spacing should be considered on all sides of the
■
dryer to reduce noise transfer.
24 in.
min.
2
(155 cm
)
2
For closet installation, with a door, minimum ventilation
■
openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation openings are
acceptable.
Companion appliance spacing should also be considered.
■
Back view:
"*
3
/
4
(18 mm)
14
/
"
3
8
(365 mm)
6
/
"
1
2
(165 mm)
29
"*
7
/
8
(759 mm)
3
/
"*
1
2
(89 mm)
6
/
"*
1
8
(156 mm)
Summary of Contents
-
Page 1
PRODUCT MODEL NUMBERS MED6000X, MED7000X, MED9000Y Front view: 27" (686 mm) " (968 mm) "* (18 mm) NOTE: Most installations require a minimum of 5" (127 mm) clearance behind dryer for exhaust vent with elbow. See “Venting Requirements.” Recommended Installation Spacing (Dryer Only): 18"...
-
Page 2
ELECTRICAL REQUIREMENTS To supply the required 3 or 4 wire, single phase, 120/240 volt, 60 Hz., AC only electrical supply (or 3 or 4 wire, 120/208 volt electrical supply, if specified on the serial/rating plate) on a separate 30-amp circuit, fused on both sides of the line. A time-delay fuse or circuit breaker is recommended.
Comments to this Manuals
Latest comments: