Maytag MED6600TQ - 27 Inch Electric Washer Use & Care Manual page 12

4. Place the hooked ends of the other direct wire cable wires under the outer terminal block 2. Connect neutral wire (white or center wire) of power supply cord to the center, silver-
screws (hooks facing right). Squeeze hooked ends together. Tighten screws, colored terminal screw of the terminal block. Tighten screw.
!! !!
5. Tighten strain relief screw.
6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-
down screw.
7. You have completed your electrical connection. Now go to "Venting Requirements."
3-wire connection: Power supply cord
Use where local codes permit connecting cabinet-ground conductor to neutral wire.
A ........ / ' I
C G F
1,
A. 3-wire receptacle (NEMA type IO-30R)
B. 3-wire plug
C. Neutral prong
D. Spade terminah with upturned ends
E. _" ( 1.9 cm) Ut listed strain relief
f. Ring term[nab
G. Neutral wire (white or center wire)
Loosen or remove center silver-colored terminal [)lock screw.
3,
A. External ground colTductol screw
B. Neutral ground wire
C. Center silver-colored terminal block screw
D. Neutral wire (white or center wire)
E. _" t 1.9 cm) U_ listed strain relief
Connect the other wires to outer terminal [)lock screws. Tighten screws.
I! !!
4. Tighten strain relief screws.
5. Insert tab of terminal block cover into slot of dryer rear paneh Secure cover with hold-
down screw.
6. You have completed your electrical connection. Now go to "Venting Requirements."
12