Cisco Callmanager Registration; Configuring Tandberg Mxp On Cisco Callmanager 4.1 - TANDBERG MXP F8 Administrator's Manual

MXP
Contents Introduction

Cisco CallManager Registration

The registration of a TANDBERG MXP in Cisco CallManager is
supported on the CallManager (CCM) 4.0 software and forward.
The TANDBERG plug in for Cisco Call Manager must be installed.
This example is valid for SCCP versions of the MXP.
Configuring TANDBERG MXP on Cisco
CallManager 4.1
Open a web browser and enter the address to the Cisco
Callmanager Administration.
Example: https://10.47.9.17/ccmadmin/
1) Log on to CallManager:
2) Select Device > ADD NEW DEVICE:
D14033.06—AUGUST 2010
Getting started The menu structure The settings library
3) Select Device Type >
4) Select Phone Type >
ENDPOINT and press Next:
Using the system Physical interfaces
PHONE and press Next: 5) Fill in the
The MAC Address is found on your TANDBERG video system.
a) Go to Control Panel > Diagnostics > System Information.
b) or use Telnet and the command: xstat //mac
TANDBERG VIDEO 6) Fill in the
ADD.
a) The Directory Number is the E.164 Alias and is found on your
TANDBERG video system. Go to Control Panel > Network > LAN
Settings > H.323 Settings > E.164 Alias.
b) In the
ANSWER RING
from 1 to 300 seconds.
You have now successfully configured the Cisco CallManager with a
TANDBERG MXP system!
When the TANDBERG MXP system is registered to a Cisco
CallManager, it will be possible to place and receive calls from this
system to any other video and voice systems that are registered on
the same Cisco CallManager.
Administrator Guide
Peripheral equipment Appendices Appendices
PHONE CONFIGURATION and press INSERT.
DIRECTORY NUMBER CONFIGURATION
FORWARD AND PICKUP SETTINGS enter the time of
DURATION. The time selected has to have a value
Contact us
and press
NO
327