TANDBERG MXP F8 Administrator's Manual page 186

MXP
Contents Introduction
MENU ADDRESS SETTINGS DESCRIPTION
Control Panel > SHARPNESS & MOTION
Call Quality > Video Quality can be set for Main Camera, PC, VNC, VCR, AUX, Document Camera and Split Screen. The
choices available are depending on what equipment is connected to the video system.
VIDEO QUALITY
SHARPNESS*: When Video Quality is set to Sharpness, the system will transmit HD at all bit rates, if
permitted by the far end.
When set to Sharpness the video is optimized for sharp video (4CIF/4SIF, SVGA, XGA, w720p).
•
The Precision HD Camera will prefer w720p.
MOTION*: When Video Quality is set to Motion and the system has a HD camera connected through LVDS,
and the bit rate is equal or above 1152kbps, the system will transmit HD.
When set to Motion the video is optimized for smooth motion video:
•
For low bandwidths: CIF/SIF or w288p
•
For high bandwidths: 448p/400p, Interlaced CIF (iCIF) / Interlaced SIF (iSIF) or w448p.
•
The Precision HD Camera will prefer: w288p for low bandwidth, w488p from 512 kbps bandwidth and
w720p from 1472 kbps bandwidth.
AUTO: The Split Screen setting can be set to Auto. When the Split Screen is set to Auto the system will
choose the best of Motion or Sharpness depending on picture layout and bandwidth.
* TANDBERG 550MXP and the TANDBERG 1000MXP do not transmit the following video formats: 448p,
400p, iCIF, iSIF, w288p, w448p, w576p, and w720p.
Control Panel > CALL TYPE
Some network configurations may cause the setup of a video call to fail. The call will then be set up as a
Call Quality >
telephone call. This setting requires the setting Fallback to Telephony to be enabled.
DEFAULT CALL SETTINGS
Select the default Call Type to be used when making a call. The default Call Type can be set to:
VIDEO CALL: The call will be set up as a video call.
TELEPHONE CALL: If either the
selected when making a call, the call will be set up as a telephone call. In all other cases the call will be
set up as a video call.
D14033.06—AUGUST 2010
Getting started The menu structure The settings library The settings library
Call Type is set to Telephone Call or the
Using the system Physical interfaces
INFORMATION
The default Video Quality settings are:
•
The Main Camera, VCR, AUX and Split Screen have Motion
as default.
•
The PC, Document Camera and VNC have Sharpness as
default.
About intelligent Video Management (IVM)
It is possible to configure the picture sent from the system
depending upon specific requirements and applications adding
an additional level of flexibility and adaptability.
Generally, the IVM will always try to transmit the format closest
to the video input format based on the configuration of the
motion and sharpness.
For MULTISITE
you to specify both telephone calls and video calls in the same
conference. This is done from the Call Menu when you make
the calls.
Place Telephone Call icon is
Administrator Guide
Peripheral equipment Appendices
(optional feature) calls, the Call Type enables
Contact us
PRODUCT
All MXP
systems
All MXP
systems
186