TANDBERG MXP F8 Administrator's Manual page 207

MXP
Contents Introduction
MENU ADDRESS SETTINGS DESCRIPTION
Control Panel > T1 LINE CODING
Network > B8ZS: Indicates how the signals on the line should be coded.
ISDN, External, Leased E1/T1 > B8ZS-RESTRICTED: If parts of the line between the systems use restricted coding, this should be selected.
LEASED E1/T1 SETTINGS
Control Panel > T1 CABLE LENGTH 1
Configures the ISDN-PRI Line Settings.
Network >
Specify the distance (0-133 ft) of the CSU connected to the E1/T1 Port 1 on Codec 1.
ISDN, External, Leased E1/T1 >
Leased E1/T1 Settings
LINE SETTINGS
Control Panel > E1 CRC-4
Network > E1 CRC-4 is used for most E1-PRI configurations.
ON: Select On if E1 CRC-4 is supported by your E1 network equipment.
ISDN, External, Leased E1/T1 >
OFF: Select Off if E1 CRC-4 is not supported by your E1 network equipment.
Leased E1/T1 Settings
LINE SETTINGS
D14033.06—AUGUST 2010
Getting started The menu structure The settings library The settings library Using the system Physical interfaces Peripheral equipment
INFORMATION
B8ZS - Binary 8 Zeros Substitution
NOTE! All settings must be identical on both sides of the
Leased E1/T1 connection.
CSU = Channel Services Unit
CRC - Cyclic Redundancy Check
Administrator Guide
Appendices Contact us
PRODUCT
Systems
with leased
line
Systems
with leased
line
Systems
with leased
line
207