Loading Paper In The Bypass Tray - Ricoh Aficio SP 3500N Hardware Manual

3. Press the [ ] or [ ] key to display [Paper Type], and then press the [OK] key.
Paper Input:
Paper Type
4. Press the [ ] or [ ] key to select the paper tray, and then press the [OK] key.
In this example, [Tray 1] is selected.
Paper Type:
Tray 1
5. Press the [ ] or [ ] key to select the paper type, and then press the [OK] key.
Tray 1:
Plain Paper
6. Press the [Menu] key.
• Duplex printing is not possible for [Thick Paper 2], [Bond Paper], [Cardstock], and [Label Paper].
• If the [Auto Continue] setting under [System] is enabled, the printer ignores the paper type and size
settings and prints on whatever paper is loaded. Printing stops temporarily when the error is
detected, and restarts automatically after about ten seconds using the settings made on the control
panel.

Loading Paper in the Bypass Tray

• Before printing on paper other than envelopes, make sure that the levers inside the rear cover are
pulled up. Leaving the levers lowered can cause print quality problems when printing on paper
other than envelopes.
• After loading paper in the tray, specify the paper type and size using the control panel to avoid
printing problems. This printer does not detect the paper size automatically.
• Load paper with the print side up and in the short-edge feed direction.
• If paper is curled, straighten it before loading, by bending the paper in the opposite direction to the
curl, for example.
• Do not load paper while the printer is printing.
• Make sure paper is not stacked above the paper guides inside the bypass tray.
Loading Paper
79