1. Insert the two tabs on the bottom of the bezel into the matching holes on the
2. Push the top of the bezel toward the computer until the two tabs at the top of
Removing and installing the support bracket
When working with some devices, such as hard disk drives, adapters, and memory
modules, you must first remove the support bracket to access the device.
Complete the following steps to remove the support bracket:
1. Remove the side cover (see "Removing the side cover" on page 39).
2. Pull out on the rear end of the support bracket approximately 150 mm (6 in.).
42
IBM IntelliStation Z Pro Type 6221: Hardware Maintenance Manual
computer chassis.
the bezel snap into place.