Cst Port Configuration - NETGEAR GS108T-200NAS Software Administration Manual

CST Port Configuration

Use the Spanning Tree CST Port Configuration page to configure Common Spanning Tree (CST)
and Internal Spanning Tree on a specific port on the switch.
To display the Spanning Tree CST Port Configuration page, click SwitchingSTPAdvanced 
CST Port Configuration.
Figure 3-18
To configure CST port settings:
1. To configure CST settings for a physical port, click PORTS.
2. To configure CST settings for a Link Aggregation Group (LAG), click LAGS.
3. To configure CST settings for both physical ports and LAGs, click ALL.
4. Select the check box next to the port or LAG to configure. You can select multiple ports and
LAGs to apply the same setting to the selected interfaces. Select the check box in the heading
row to apply the same settings to all interfaces.
5. Configure the CST values for the selected port(s) or LAG(s):
• STP Status. Enable or disable the Spanning Tree Protocol Administrative Mode
associated with the port or port channel.
Configuring Switching Information
GS108T and GS110TP Smart Switch Software Administration Manual
v1.0, April 2010
3-27